2-Step Cabin Tent Setup Instructions
Component List
2-Step Cabin Tent x1
Tent Bag x1
Gear Compartment x1
Pegs & Guylines x1 set
Battery x1
Tent Assembly
Step 1: Unroll the tent & lay flat on the floor.
Unfold and spread the tent to lay it flat on the ground.
Step 2: Peg the 4 corners to the ground.
Locate the 4 corner loops at the base of the air beam.
Use the tent pegs provided to secure each corner to the ground.
Ensure the tent is pulled snug but not overly tight, giving it a sturdy foundation.
Step 3: Close both valves.
Two valves are located on separate air beams, each labeled with the word "Valve".
Close both valves tightly, ensuring they are fully tightened and sealed to prevent air loss.
After closing them tightly, make sure the sleeves adequately cover the valves to prevent damage from rain.
Step 4: Install the battery and turn it on.
Step 5: Now let the tent work its magic.
Allow the tent to perform its function. When the air pump stops, lift the air beams.
Once it's fully inflated, the pump will stop automatically.
If you need to pause the inflation, press the same button once, and it'll stop the inflation. Press again to continue.
NOTE: The smart safety valve automatically releases air when the pressure in the beams becomes too high. This prevents over-inflation, especially in hot weather.
Step 6: Peg the pre-assembled guylines.
Once fully inflated, locate and peg down the 4 guylines.
Step 7: Open the roof air vents.
There are four vents on the roof.
Open each flap and attach the Velcro to the bottom of the flap. The flap should stay open with the help of the Velcro.
Tent Disassembly
Step 1: Remove the pegs and the battery. Place them back into the small compartment in the tent bag. Then, close the roof air vents.
Step 2: Open the two valves to release the air.
Step 3: Let the tent collapse and push out as much air as possible so the tent is flat.
Step 4: Fold the tent.
Fold both sides of the tent inward.
Once folded inward, take each folded side and fold again towards the middle.
Finally, fold the tent in half once more, aligning the edges neatly.
Step 5: Once the tent is folded into a long, narrow rectangle, start rolling it up slowly.
Squeeze out all the air as you roll the tent, ensuring that you roll and squeeze simultanerously.
This will help prevent the tent from becoming bulky when you finish rolling it up.
Step 6: Place the tent back into the tent bag. Pull the drawstring to tighten the bag. Buckle it up and pull the strap to secure the tent.
If you still have any questions on the setup and takedown process, email us at
We will get back to you as soon as we can.
Happy Camping! :)